Dynamode NC100TX-R Fiche technique télécharger pdf

NC100TX-R

FEATURES

INTRODUCTION

Single-chip controller complies to PCI local bus specification revision 2.1

Conforms with IEEE 802.3 I0BASE-T and IEEE 802.3u l00BASE-TX standards.

High performance bus master architecture for low CPU and bus utilization.

Single shielded RJ-45 connector for using at either 10 or l00Mbps speed.

Single +5 V power supply operation.

On-board socket for an optional remote boot ROM.

Provides I diagnostic LED to monitor linking status.

Provides high performance network drivers such as ODI, NDIS, NDIS3, NDIS4, NDIS5, UNIX, etc.

Support optional Boot Rom chip.

Dynamode

10/100Mbits Realtek Ethernet. Card (with boot Rom Option)

32-bit 100/l0M PCI adapter. This is a 32-bit adapter for using in personal computers with a

Peripheral Component Interconnect (PCI) computer bus to eliminate I/O bottlenecks and to

reduce CPU loading using bus master architecture.

This is also a Full-Duplex adapter connected to an Ethernet network with a single connection

over unshielded twisted pair (UTP) cable and can auto-sense either 10 Mbps or 100 Mbps by

full auto-detection.

Dynamode 1

Résumé du contenu

Page 1 - Dynamode

NC100TX-RFEATURESINTRODUCTIONSingle-chip controller complies to PCI local bus specification revision 2.1Conforms with IEEE 802.3 I0BASE-T and IEEE 802

Commentaires sur ces manuels

Pas de commentaire

Dynamode NC100TX-R Fiche technique

Naviguer en ligne ou télécharger Fiche technique pour Cartes de réseautage Dynamode NC100TX-R. Dynamode 10/100Mbps PCI Network Card Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Cartes de réseautage Dynamode NC100TX-R